Knowledge
-
27
Jul
What are some common cleaning problems with automatic drip dispensers?1. Incomplete Residue Cleaning: Electrolyte crystals and material residues on pipes, injection racks, and electronic scale trays are not completely wiped away. Long-term accumulation can corrode expos
Read More -
24
Jul
How to determine if an automatic drip machine needs maintenance?1. Abnormal Drip Operation: Unstable dripping rate, intermittent dripping, significant deviation of the output from the set value, and poor reproducibility of repeated parallel tests indicate wear or
Read More -
22
Jul
How to regularly maintain an automatic dripping machine1. Daily Maintenance: After operation, flush the flow channels with a compatible solvent to prevent liquid crystallization and blockage. Clean any spilled liquid from the tray below the injection need
Read More -
20
Jul
What are some common causes of malfunctions in automatic liquid dispensing ma...1. Piping and Circuit Faults: Air bubbles inside the burette or circuit will directly affect titration accuracy; loose connecting nuts on the three-way valve or suction tube will cause air or liquid l
Read More -
17
Jul
What are some common reasons why an automatic dispensing machine needs calibr...1. Accuracy Drift: Uneven liquid temperature, air bubbles, and nozzle blockage can directly cause unstable dripping speed and excessive output deviation. Long-term use leading to wear and loosening of
Read More -
15
Jul
How to solve common problems in the calibration of automatic dripping machinesI. Unstable Potential Reading First, check if the electrode wiring is intact. If the pointer still fluctuates after removing the reference electrode, use a multimeter to check if the electrode wiring
Read More -
13
Jul
What are some common calibration problems with automatic dispensing machines?I. Potential/Measurement Issues: Unstable and fluctuating potential readings are often caused by electrode aging and contamination, external electromagnetic interference, or poor grounding. Large devi
Read More -
10
Jul
How to manually calibrate an automatic dripping machineI. Preparation Before Calibration Maintain a laboratory temperature of 20±5℃ and humidity ≤70%. Prepare a calibrated electronic balance with an accuracy ≥0.1mg, volumetric flasks, and dis
Read More -
08
Jul
How to Test the Accuracy of an Automatic Dripping Machine1. Preparing the Environment: Maintain an ambient temperature of 20℃-25℃ and humidity of 60%-80%. Avoid sources of strong vibration and electromagnetic interference. Prepare calibrated volumetric flas
Read More -
06
Jul
Which part of a fabric dyeing machine is most prone to wear?1. Fabric Lifting Roller: This is the core component of traditional overflow and bottom-feed dyeing machines. It continuously drives the fabric in circulation, and the dry fabric surface and the rolle
Read More -
03
Jul
Which fabric dyeing machine parts need to be replaced regularly?1. Fabric Guide Strips (Fabric Lifting Wheel Strips): Standard EPDM material strips will harden and crack within 3-6 months at 130℃. Fluorosilicone modified strips have a lifespan of approximately 18
Read More -
01
Jul
How to determine if parts of a fabric dyeing machine need to be replaced?1. Operating Status Assessment: When a component exhibits a significant performance decline, frequent abnormal noises, or recurring malfunctions that cannot be resolved through conventional debugging,
Read More




