1. Independent Dyeing Chambers/Disposable Consumables
• Each slice or piece of fabric is placed in a separate chamber; dye and nozzles are disposable, preventing backflow and sharing.
• Spray a non-stick coating on the inner wall of the chamber to reduce dye buildup.
2. Dedicated Piping + Check Valves
• Each reagent has its own peristaltic pump and tubing, with a check valve/solenoid valve at the front end to prevent backflow.
• For high-viscosity or easily crystallized dyes, use a large-diameter, short tubing design to minimize dead spots.
3. Process Isolation + Air Barriers
• Set an "air barrier" or "cleaning interval" in the software: After each sample is completed, the system automatically draws in air before switching reagents to prevent color mixing.
• When supporting multiple turntables or multiple channels in parallel, assign independent channels to different projects and prevent cross-calling. 4. Automatic Cleaning and Direct Waste Discharge
• Immediately after staining, a three-stage cleaning process ("printer head-pipeline-staining chamber") is initiated: pure water → ethanol → pure water, with a rinse time of 30-60 seconds.
• Waste liquid is discharged directly into a sealed waste tank via a peristaltic pump, without passing through a valve or needle, to prevent reverse contamination.
5. Daily Monitoring and Recording
• A blank control is performed before each startup: the entire process is run using a clean slide. Only after microscopic examination confirms no residual color can samples be loaded.
• The software records each batch of reagents, including lot number, drop volume, temperature, and number of washes, enabling traceability in the event of an abnormality.





