How to eliminate the electrical fault of the stock solution preparation system?

Nov 18, 2024 Leave a message

1. Analysis of fault phenomenon:
1. Not working:
Power supply problem: Check whether the plug and socket are properly plugged in, whether the power cord is damaged, whether the circuit breaker is tripped, and use a multimeter to measure whether the power supply voltage is normal.
Control circuit failure: Check whether the controller has a display or alarm, and check whether the wiring of the control circuit is loose, detached or short-circuited.
Motor failure: Check whether the motor has odor, heat or abnormal sound, and use a multimeter to measure whether the resistance value of the motor winding is normal.
2. Abnormal operation:
Unstable stirring speed: Check whether the motor speed is stable, whether the transmission belt or chain is loose or worn, and whether the agitator is installed firmly.
Abnormal temperature: Check whether the heating or cooling system is working normally, whether the temperature sensor is damaged, and whether the thermostat is set correctly.
Leakage: Check whether the joints of pipes, valves, pumps and other components are well sealed and whether there is leakage.
2. Common fault locations and troubleshooting methods:
1. Power supply part:
Fuse blown: Find out the cause of the blown fuse, such as overload, short circuit, etc., and replace the fuse.
Contactor failure: Check whether the contact of the contactor is burned or adhered, and whether the coil is damaged. If there is a problem, replace the contactor.
Transformer failure: Check whether the primary and secondary windings of the transformer are short-circuited or open-circuited, and whether the insulation is good. If there is damage, replace the transformer.
2. Control circuit part:
Relay failure: Check whether the contacts of the relay are normal and whether the coil is damaged. If there is a fault, replace the relay.
Controller failure: Check whether the controller program is correct, whether the parameter settings are reasonable, and whether the input and output signals are normal. If there is a problem, repair or replace the controller.
Sensor failure: Check whether the temperature sensor, pressure sensor, liquid level sensor, etc. are working normally, whether the signal is accurate, and if there is damage, replace the sensor.
3. Motor part:
Motor winding short circuit: Use a multimeter to measure the resistance value of the motor winding to determine whether it is short-circuited. If there is a short circuit, replace the motor.
Motor overload: Check whether the load of the motor is too large, whether there is a stuck phenomenon, and if there is a problem, eliminate the cause of overload.
Motor phase loss: Check whether the three-phase power supply of the motor is normal, whether there is a phase loss phenomenon, if there is a phase loss, find out the cause and repair it.
3. Use of testing tools and instruments:
Multimeter: can measure parameters such as voltage, current, resistance, etc., to help determine the on and off of the circuit and the quality of components.
Megohmmeter: used to measure the insulation resistance of equipment such as motors and cables.
Oscilloscope: observe the signal waveform in the circuit and analyze the cause of the fault.
Clamp ammeter: measure the current in the circuit.
4. Safety precautions:
Power-off operation: before troubleshooting electrical faults, be sure to cut off the power supply and hang a "no closing" warning sign.
Prevent electric shock: during operation, pay attention to prevent electric shock accidents and avoid touching live parts with your hands.
Use tools correctly: when using testing tools and instruments, follow the correct methods and operating procedures to avoid damaging the equipment.
Seek professional help: if you are not familiar with or unsure about troubleshooting electrical faults, you should seek help from professional electrical maintenance personnel in time to avoid causing greater losses.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry