Mechanical Component Rust Inspection
1. Guide Rail Inspection: Visually inspect the guide rail surface for rust spots, scratches, or abnormal wear. Rust spots are usually reddish-brown or dark yellow and may be accompanied by a rough surface. If shallow grooves of varying depths are found on the guide rail end face, it may be a sign of rust caused by friction between the metal and the guide rail due to wear of the guide shoe liner.
2. Gear and Bearing Inspection
Gears: Check the gear teeth for rust, pitting, or peeling. Rust will damage the tooth surface lubrication and accelerate wear.
Bearings: Observe the inner and outer rings, cage, and steel balls for rust spots. Rust will cause the bearing temperature to rise and the grease to thin, leading to failures such as "outer diameter slippage," "inner diameter slippage," or "disintegration."
3. Fasteners and Transmission Devices: Check whether bolts, nuts, and other fasteners are loose or broken due to rust. Rust will reduce their strength and affect the stability of the equipment. Protection Status and Water Accumulation Inspection
1. Drainage Outlets and Residual Water: Check for blockages in the equipment's drainage outlets. Residual water will accelerate the corrosion of metal parts. Ensure unobstructed drainage and avoid prolonged damp environments.
2. Wiring Insulation Protectant: Check if the wiring insulation protectant on electrical cabinets, motor end covers, etc., has failed (e.g., cracked, peeling). Failure will allow moisture to enter, causing corrosion or short circuits in electrical components.
3. Engine Coating: Observe if the engine surface coating has peeled off. The coating protectant isolates air and moisture; peeling will expose the metal surface, increasing the risk of corrosion.
Comprehensive Judgment and Handling Recommendations
1. Rust Degree Assessment: If rust is limited to the surface, it can be treated by removing rust and re-lubricating or applying rust inhibitor. If it has caused component deformation or functional failure (e.g., bearing jamming, gear misalignment), the component needs to be replaced.
2. Preventive Measures: Clean the equipment regularly, maintain a dry environment, and apply grease or rust inhibitor periodically.





