1. Stress Corrosion
Symptoms: Under high-temperature and high-pressure environments, temperature fluctuations in the dye solution can cause cracks or perforations in metal parts of the equipment (such as the cylinder and pipes).
Countermeasures:
Use corrosion-resistant materials (such as 316L stainless steel) for key components.
Optimize structural design to reduce stress concentration areas.
Regularly inspect cylinder welds and seals to prevent dye leakage.
2. Uneven Dyeing or Color Variation
Causes:
Nozzle clogs or uneven gaps, resulting in poor fabric circulation.
Dye circulation pump malfunctions or filter clogs.
Solutions:
Clean the nozzle and filter, and adjust the nozzle gap to a uniform level.
Check the circulation pump for normal pressure (maintain a water pressure of 1-2 kg/cm²).
3. Abnormal Temperature Control
Symptoms: Unstable heating rate or overtemperature alarm (>150°C). Handling:
Calibrate the PT100 temperature probe to ensure a temperature control accuracy of ±6°C.
Check the steam valve for leaks and replace the seal if necessary.
4. Fabric knots or jams
Cause:
Excessive fabric speed or wear on the fabric guide roller.
A low bath ratio (<1:3) increases fabric friction.
Solution:
Adjust the fabric speed to a reasonable range (usually 0.5-1.5 m/s).
Check the lubrication of the fabric guide roller bearings and add high-temperature lubricant.
5. Abnormal safety valve or pressure
Symptom: The equipment pressure exceeds the set value (e.g., 10 kg/cm²) or the safety valve trips frequently.
Countermeasure:
Regularly test the safety valve sensitivity and clean any impurities inside the valve.
Check the pressure sensor for malfunctions to avoid false alarms.
6. Electrical system malfunction
Common problems:
The control panel is unresponsive or the program is interrupted.
The motor is overheated or the overload protection is triggered. Solution:
Restart the power supply and check for loose connections.
Replace any damaged cables or fuses.





