1. Lockout/Tagout (LOTO):
Before beginning any mechanical or electrical work, always perform a complete lockout/tagout procedure. This involves completely disconnecting the machine from the power source and locking the circuit breaker to prevent accidental activation.
2. Personal Protective Equipment (PPE):
Technicians must wear heat-resistant gloves, chemical-resistant goggles, and steel-toed safety boots to protect themselves from high temperatures, corrosive chemicals, and mechanical hazards.
3. Confined Space Entry:
Confined space entry, such as cleaning inside dye tanks, requires strict safety protocols. Before entering, technicians must ensure adequate ventilation, perform gas and oxygen level checks, and always have a supervisor present.
4. Pressure Relief:
Before opening any covers or inspection doors, ensure all inlet and outlet valves are closed to isolate the steam container. Fully open the drain and vent valves to release any pressure or vacuum within the container.
5. Check the Pressure Gauge:
Open any covers or inspection doors only when there is no residual pressure within the container. Verify that the pressure gauge is calibrated and displays zero pressure. 6. Operating Temperature:
Do not open the lid or inspection door while the vessel is still pressurized and the operating temperature exceeds 80°C.
7. Interlocks:
Interlocks must not be bypassed or interfered with.
8. Cleaning and Inspection:
Before each operation, check the connections for ventilation, drainage, pressure gauges, and water level gauges for blockage.
9. Emergency Procedures:
Each steam receiver should have simple operation instructions and emergency/accidental response procedures displayed in a conspicuous location, and all operators should be fully familiar with these procedures.
10. Chemical Use:
Chlorine-containing dyeing chemicals should not be used in stainless steel vessels/dyeing machines without the equipment manufacturer's consent.
11. Regular Inspections:
The entire machine should be regularly inspected, and the pressure gauge and temperature gauge should be checked frequently. Ensure that the readings on the pressure and temperature gauges match. If any abnormality is detected, repair or replace them immediately.
12. Cooling Down and Shutdown:
After dyeing is completed, cool down the machine. The lid may not be opened until the pressure has dropped to zero, the temperature has dropped below 90°C, and the machine has stopped.





