Rolling mills can be classified according to the arrangement and number of rolls, and according to the arrangement of the stands.
Two rollers
It has simple structure and wide range of uses. It is divided into reversible and irreversible. The former include blooming mill, rail beam rolling mill, plate rolling mill, etc. Irreversible types include billet continuous rolling mills, stacked thin plate rolling mills, thin plate or strip cold rolling mills, skin pass mills, etc. The largest two-high rolling mill in the early 1980s had a roll diameter of 1500 mm, a roll length of 3500 mm, and a rolling speed of 3 to 7 m/s.
Three rollers
The rolled piece is rolled alternately from the upper and lower roll gaps to the left or right. It is generally used as a section steel rolling mill and a rail beam rolling mill. This mill has been replaced by a high-efficiency two-high mill.
Lauter three-roller
The upper and lower rollers are driven, the middle roller is floating, and the rolling stock passes alternately above or below the middle roller. Because the diameter of the middle roller is small, the rolling force can be reduced. It is often used for rolling rail beams, section steel, medium and thick plates, and can also be used for blanking small steel ingots. This kind of rolling mill was gradually replaced by the four-high rolling mill.
Rolling mill type classification
Jan 05, 2024 Leave a message
Send Inquiry




