How to extend the service life of a sand dyeing sample machine?

Nov 03, 2025 Leave a message

I. Daily Maintenance Guidelines
1. Immediate Cleaning
After each use, thoroughly clean the dye cup, pipelines, and sieve to remove residual dye and prevent solidification and blockage.
Check the guide rails and transmission parts weekly, wipe off dust with a soft cloth, and replenish lithium-based grease.
2. Lubrication Management
Bearings need to be cleaned and the lubricant replaced every 500 hours (high-temperature sodium-based grease is recommended). The amount of lubricant should be controlled to 1/2~2/3 of the bearing housing volume.
Apply special lubricating oil to transmission parts such as chains and gears every 300 hours.
II. Key Component Maintenance
1. Inspection of Wear Parts
The grinding wheel/grinding media should be replaced when wear exceeds 1/3 to avoid uneven dyeing.
Check the aging of the sealing ring every 6 months; for high-temperature models, this should be shortened to 3 months.
2. System Calibration
Calibrate the temperature sensor and pressure gauge monthly; adjust if the error exceeds ±2℃.
Disassemble and clean the dynamic separator quarterly to prevent a decrease in discharge accuracy.
III. Operation Optimization Suggestions
Process Control: Avoid overloading the machine; dyeing parameters should be adjusted according to the dye characteristics.
Environmental Management: The humidity of the equipment storage area should be below 65%, and it should be kept away from corrosive gases.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry