Inspection of Rust Condition of Mechanical Components
Visual and tactile inspection of key parts of the equipment is the most direct way to determine rust prevention needs.
1. Visual Inspection: Observe the surface of the equipment for rust spots, rust marks, or corrosion. Pay particular attention to key areas such as around shaft holes, anchor bolt connections, and flange contact surfaces. If spot rust is found with a depth exceeding 0.1mm, or if yellowish-brown rust seeps from crevices, it indicates internal corrosion and requires immediate rust prevention treatment.
2. Coating Condition: Inspect the protective layer (such as paint or galvanized layer) for peeling, cracking, or flaking. If the damaged area exceeds 10% of the total area, or if key areas show localized damage (diameter > 5mm) exposing the substrate, recoating is required. Severe loss of gloss, chalking, or large-area fading of the coating also indicates protective failure.
Protection Status Assessment
The integrity and functionality of the protective layer are the core indicators of rust prevention maintenance.
1. Coating Thickness Inspection: Measure the thickness of the paint or zinc layer using a coating thickness gauge. If the coating thickness of critical areas (such as stress-bearing surfaces or outdoor exposed surfaces) is less than 50% of the design value (general coating total film thickness ≥140μm, zinc plating ≥85μm), recoating is required.
2. Adhesion Test: Score a cross pattern on the coating surface with a blade, apply tape, and quickly peel it off. If the area of coating peeling off exceeds 30% of the area within the grid, it indicates adhesion failure, and enhanced protection is required.
Environmental Control Factor Analysis: The environment in which the equipment is located has a significant impact on the risk of rust. Maintenance strategies need to be adjusted according to environmental characteristics.
1. Environmental Corrosion: If the equipment is moved from indoors to outdoors, or to a more corrosive environment such as a humid chemical environment, the original coating may not be able to withstand it. Recoating is recommended even without obvious damage. For J-type high-temperature high-speed dyeing machines, the presence of chloride ions in the dye solution will accelerate the formation of stress corrosion cracks and fatigue cracks, requiring more frequent rust prevention inspections. 2. Service Life: If more than 5 years (outdoor) or 8 years (indoor dry environment) has passed since the last coating, rust prevention maintenance is recommended even without obvious damage.
Comprehensive Judgment and Priority: Based on the inspection results, handle according to the following priorities:
1. Immediate Handling: Localized corrosion or coating damage in critical load-bearing areas (such as bearing mounting positions and the area around the output shaft hole) requires immediate recoating to avoid affecting structural strength.
2. Planned Maintenance: If the coating thickness or adhesion is substandard, but the equipment can still operate for a short period, a coating plan should be developed to prevent the malfunction from escalating.
3. Environmental Adaptability Adjustment: For equipment in highly corrosive environments or that has not been maintained for a long time, even if it is in good condition, it should be included in the maintenance cycle in advance.





